Ideal Commercial

FAQs about Commercial Heating

  • What is the best commercial boiler in the UK?

    Evomax 2 is the UK’s number one wall-mounted commercial boiler. The range is available in outputs from 30kW to 150kW and up to 6 boilers can be cascaded for outputs up to 900kW.

    An Evomax 2 three-boiler cascade can be built in less than 90 minutes when using our prefabricated frame and header kits - watch our video now! How quickly can you build a three-boiler cascade?

  • Do you offer free commissioning on the Evomax 2?

    Yes, Ideal Heating offers free commissioning on its commercial products. This needs to take place within three months of installation to qualify for full warranty.

    The free commissioning service is available on the following products: Evomax 2, Imax Xtra 2, Imax Xtra EL, Evomod commercial boilers, the EQMAX water heaters and ECOMOD commercial heat pumps.

    To take advantage of their market-leading free commissioning service, simply fill in a few details: Free Commissioning Request

  • Do wall hung boilers fitted in cascade improve part-load efficiency?

    Yes, this is one of the main engineering arguments for a cascade. A single large boiler often sits well below its rated output for most of the year and can short-cycle at low loads, while a cascade of smaller Evomax 2 units matches output to demand by staging boilers on and off individually, so each running unit operates closer to its efficient firing range.

  • How many Evomax 2 boilers can you cascade?

    You can cascade up to 6 Evomax 2 boilers for outputs up to 900kW.

    Evomax 2 wall-mounted commercial boiler is available in outputs 30kW – 150kW. Find out more about the Evomax 2 the UK’s number one wall-mounted commercial boiler at: Evomax 2 Cascade and PHEX

  • What flue arrangements are required for a wall hung boiler cascade system?

    Flue design becomes a bigger part of the plant room layout as cascade size increases, since each wall hung boiler in the Evomax 2 cascade system typically needs its own flue run or a shared terminal arrangement designed to manage the combined plume. This is very site-specific, so our specification team usually reviews flue routing alongside the cascade configuration rather than treating them as separate decisions.

  • What is a buffer tank and how does it work with a heat pump?

    A buffer tank is typically an insulated vessel of water; it doesn’t usually contain any coils or heat exchangers; most will have top and bottom connections, and some will have a baffle plate internally. The primary role of a buffer tank is to keep a minimum volume of water ‘in circuit’ at times when the heating load is very low. This prevents the heat pump from short cycling and provides a bypass route to maintain the minimum flow rate through the heat pump if most of the heating zones have shut down.

  • How noisy are heat pumps?

    Our heat pump noise levels go as low as 64 dB(A).

  • What is a hybrid heating system?

    This is where the heating system uses different fuel sources to heat the building. This can be a mix of technologies for example an ASHP working alongside a traditional boiler to obtain the best efficiency from either appliance.

  • Can a heat pump replace a boiler?

    Yes. In most cases if the heating system has been sized correctly, a heat pump is a suitable alternative to a traditional fossil fuel system.

  • What are the differences between each refrigerant (R410A, R32, R290)?
    • R744 Carbon Dioxide CO2: Natural refrigerant with ultra-low GWP of 1, very eco-friendly and non-flammable.

    • R290 Propane: Natural refrigerant with ultra-low GWP of 3, very eco-friendly and highly flammable.

    • R32 HFC-32: Lower GWP of 675, eco-friendly, mildly flammable, lower cost, most popular refrigerant choice.

    • R410A Puron,AZ-20: Slowly being phased out, higher GWP of 2088, worse for the environment, non-flammable, higher costs.

    • R407c Klea66: Still used but will be phased out in 2025 in systems with less than 3kg charge, high GWP of 1774.

  • Can a heat pump be used with radiators?

    Absolutely, heat pumps work very well with radiators as long as they are sized correctly.

  • Are our heat pumps safe?

    Yes, heat pumps have been installed around the world for over 50 years and are rigorously tested in the most extreme conditions.

Join our mailing list

Stay up to date with the latest news, products and updates from Ideal Commercial. Simply complete your details below to subscribe.

Fields marked with an asterisk * are required
Enquire about our training courses

Complete your details below and we'll be in touch about our commercial heating training courses.

Your details