Ideal Commercial

FAQs about Commercial Heating

  • What is the difference between direct and indirect HIUs?

    HIUs come in direct or indirect models. Direct HIUs usually have just the one heat exchanger that may separate heating or hot water from the network; at least one of the services they provide through a direct connection between the network and either the dwelling heating or hot water system. For example, the POD Direct units allow circulation of the actual heat network water directly through your home’s radiators

    Indirect HIUs typically have two heat exchangers in the appliance and provide complete separation between the heat network for both heating and hot water. Indirect units use a separate heat exchanger to create a physical "pressure break," isolating the home's internal heating loop and hot water system from the main network loop for safety and reliability. Ideal Heating’s range of POD HIUs are available in both types, with domestic hot water outputs from 30 – 70kW, and feature highly efficient stainless steel brazed plate heat exchangers, see more about the range here

  • What are the components of a Heat Network?

    There are three core parts to a heat network: the energy centre, the distribution network, and the heat interface unit (HIU).

    The energy centre is the central plant room or dedicated building housing all the equipment responsible for generating or collecting the thermal energy, for storing it or transferring it to the water in the network, and pumping that water around the heat network.

    The distribution network consists of all the pipework and any valves or ancillary equipment that distributes and balances the flow across the network. This might be buried in the ground or run up through risers in a building.

    The heat interface unit (HIU) is at the point of use within the dwelling. This is the appliance that transfers the thermal energy from the network to provide heating and hot water for the end user. Read more here

  • Does an HIU use gas?

    Heat Interface Units or HIUs do not use gas or burn any fuel. They rely entirely on thermal energy supplied via insulated pipes from a central plant room or central energy centre.

  • How does district heating work?

    District heating, also known as heat networks, deliver hot water from a central energy centre to end users’ properties through a network of insulated pipes. In every property a Heat Interface Unit then uses heat exchangers to transfer thermal energy from the water in the distribution network to the water in the central heating or to generate instantaneous domestic hot water.

  • Do Ideal Heating sell heat interface units?

    Yes, with the advent of low carbon domestic heating in the UK, and in particular heat networks, Ideal have applied their years of knowledge and experience creating market leading domestic appliances to create the POD heat interface unit. Available in Indirect and Direct models, there is a variant for every heat network. POD has been designed to look and work like a domestic heating appliance and will easily fit in a kitchen cupboard. Read more about heat networks and heat interface units

  • Do Ideal's commercial boilers meet Part L and low-NOx rules?

    Ideal's commercial condensing boilers are built to exceed current Part L minimum efficiency requirements and meet NOx Class 6, making them a high efficiency commercial boiler choice where local planning conditions or air quality management areas set their own emissions limits alongside national Building Regulations. It's worth checking specific planning conditions for a site early, since some local authorities now apply NOx limits that go beyond the national baseline.

  • Cascade or single boiler, what should drive the decision?

    The main factors are plant room space, redundancy requirements, and how much the building's demand varies through the year: a cascade generally wins on redundancy and part-load matching, while a single large unit like the Imax Xtra EL wins on simplicity and footprint. Larger sites needing industrial boilers for continuous process loads, rather than just space heating, may weigh these factors differently again. Fuel type and site access can also tip the decision, since a pressure jet boiler brings different constraints again if mains gas isn't available.

  • Why is commissioning important for your heating or hot water appliance?

    Commissioning checks that your new boiler, water heater or heat pump has been installed and set up correctly to operate safely and efficiently. It helps optimise performance, confirm that controls work as intended and identify issues before the appliance enters normal service.

    A suitably qualified engineer follows the appliance-specific commissioning checklist, checking operating settings, safety devices and system performance. For gas boilers and gas-fired water heaters, this work must be carried out by an appropriately qualified Gas Safe registered engineer.

    To request our free commissioning service, simply complete the Free Commissioning Request form.

  • Is Ideal Heating part of Groupe Atlantic?

    Yes, Ideal Heating is part of Groupe Atlantic’s UK and Republic of Ireland divisions. They are the market leader in commercial and domestic heating across Europe.

    Based in Hull, the Groupe Atlantic UK manufacturing plant has an 800-strong workforce, with over 1,500 staff employed across all brands within the UK. Globally, Groupe Atlantic has over 13,000 employees. Groupe Atlantic products are distributed in more than 17 countries, with thirteen brands operating across: heating, hot water, air conditioning and ventilation.

  • Is Ideal Heating a British Company?

    Ideal Commercial Heating is the UK’s leading commercial heating manufacturer of high efficiency commercial heating solutions. Operating from its Hull manufacturing plant and offices since 1906, they are one of the few true British manufacturers left in the heating industry.

    With over 120 years of experience and knowledge they have developed a range of low carbon heating and hot water solutions for commercial properties.

  • Do Ideal Heating offer free commissioning on its commercial boilers?

    Yes, Ideal Heating offers free commissioning on its commercial products. This needs to take place within three months of installation to qualify for full warranty.

    The free commissioning service is available on the following products: Evomax 2, Imax Xtra 2, Imax Xtra EL, Evomod, EQMAX water heaters and ECOMOD commercial heat pumps.

    To take advantage of their market-leading free commissioning service, simply fill in a few details: Free Commissioning Request

  • Does Ideal Heating supply more than commercial boilers?

    Ideal Heating offers a comprehensive range of commercial heating and hot water solutions, developed to meet evolving building requirements, market needs and legislation. Our portfolio includes condensing boilers, commercial heat pumps, heat interface units, and the new EQMAX condensing water heater range. Backed by decades of experience and technical expertise, Ideal Heating Commercial supports the specification of reliable, efficient systems while helping customers transition towards lower-carbon heating and hot water.

Join our mailing list

Stay up to date with the latest news, products and updates from Ideal Commercial. Simply complete your details below to subscribe.

Fields marked with an asterisk * are required
Enquire about our training courses

Complete your details below and we'll be in touch about our commercial heating training courses.

Your details